This is the problematic part . Those spats shouldn't be there . As a solution I am thinking: Either I copy half the wheel in resin or I copy the entire wheel from another kit .
Work in progress . I was very happy, now that I have a little time free after work to start this project. Putting aside the fact that the engine is larger than the inside diameter of the cowling and some putty will be needed for some area's, I see that I must put this project on hold .
First problem is that the wheels are moulded with spats , which need to be removed. This is not the end, I could come up with a solution . The worse part is that decals are missing the original writing of Bücker. Until I find a solution, I'll have to put it on hold.
