chassis completed, not an easy thing to put together but got there in the end. lots of test fitting and modifying. Problem with the winch on the front which needed modifying with the parts being moulded the wrong way around.
Here's the modification to the winch with a hole drilled on one side and some plastic rod super glued on the other. Also don't go by the locating marks for the winch on the chassis as it interferes with the radiator.
One thing to note is make sure all the wheels touch the ground by glueing on the front axle and then place the chassis on a flat surface to make sure everything is level. Also the brake hubs which are attached to the wheels should be checked for square.
Plastic rod to replace the molded on bolts that had a seam line through them. To get rid of the seam line on the front axle I scraped some pastic off a piece of sprue and applied some extra thin Tamiya glue to join and placed the slivers of plastic on top
PE added for supports for the steps and fuel tanks.The mounts for the steps had to come off later as they were making the step and fuel tanks to high for the fenders.