Peżot

Dave Flitton
Keep going! This is a challenge. I would add some evergreen plastic to the tops to straighten the mold failure.

Łukasz Gliński Author
Thx, I tried, but the resin is rarely flat and I failed to conform the styrene. Gave up after couple of attempts.
The figures inside will be tasked with distracting the viewers from this flaw 😉

Alec K
You are doing a great job with this difficult kit 👍

Łukasz Gliński Author
And across the finish line! Enjoy the pics as there are not too many 😄
Very poor set, however the figurines are really nice (although I should've tweaked them a bit more, the seam lines in particular).
Next time I'm going to match Ścibor's figures with something 3D-printed

Alec K
This turned our great L. I really like those "in terrain" pics. I am with you, my stash of vintage resin kits is trash…

Łukasz Gliński Author
The thing is it's not really a vintage one 😁

Alec K
Well that's just a travesty then… 😂